This thread is so long, I am not sure if it has already been covered, but what are the recommended lubrication spots on a 1301?
Likes pretty much everything in every caliber.
https://www.youtube.com/watch?v=2o2dOyVfdEI - Start at 6:30
https://www.youtube.com/watch?v=5ogp1v8z5dU - Doesn't get into it as much but does show a bit.
Bottom line appears to be just lube up the bolt where it contacts the carrier, the outside of the carrier, and the rails inside the receiver. Keep it out of the piston.
Likes pretty much everything in every caliber.
I thought you just bought a new gun when one got dirty?
My highest round count 1301T is right around 600 rounds. I disassembled, cleaned and oiled it around 500 rounds. It didn't need it at that point though.
EDIT: I see I also cleaned and oiled it at 300 and added some oil at 430, six months later.
I think the most important PM for the 1301 is to check optics screws as they can definitely come loose.
Damn... I just cleaned mine and oiled the piston. Guess I need to disassemble again and clean the oil out.
Sent from my SM-G960U1 using Tapatalk