Thanks everyone for the input. The 1911 in question runs well so I think I’ll leave it alone for now. If it does start to show issues, I’ll make the adjustments and use the 10-8 test as a litmus.
Thanks everyone for the input. The 1911 in question runs well so I think I’ll leave it alone for now. If it does start to show issues, I’ll make the adjustments and use the 10-8 test as a litmus.
Wilson themselves sell two different 10 round mag tubes, the version with the rolled feed lips are shorter than the “47” style. I’ve had ok luck with both when using good ammo. Though you can tell there is a lot of friction with the reinforced feed lip style between those thicker feed lips and shorter tube. I don’t trust either for anything other than range use.
I believe Chip McCormicks are of the shorter variety too.
That’s good info to know.
I wonder if Tripp 10s are “longer” tubes?
If you're going to be a bear….be a GRIZZLY!
Nothing so needs reforming as other people's habits - Mark Twain
Tact is the knack of making a point without making an enemy / Where is the wisdom we have lost in knowledge?
I am thinking that my next gun purchase is going to be a Ronin commander sized pistol, 9mm.
Got a local G'smith who's good with the 1911.
I'll have him install a BP ambi safety, and call it good.
"... And miles to go before I sleep".
Been carrying my Springfield RO elite 9mm commander for almost 4 years now.
"... And miles to go before I sleep".
So another update in my pursuit to get my Wilson CQB to run 10 rd .45 mags reliably.
I was previously having problems with the gun feeding when fully loaded with 10+1 of 230 gr Federal HST. I switched from an 18lb recoil spring down to a 16lb, which seems to have corrected the issue. I ran probably 20 rounds with the gun fully loaded (topping off the mag after every round fired) and it had no issues feeding with the 16lb recoil spring. I also went with a buddy who has a Dan Wesson and we tried the same mags and ammo. He had the same malfunction that I was previously having with 10+1 loaded. His gun has an 18.5lb recoil spring but he was unsure of the mainspring weight. I didn't try the 16lb spring in his gun.
Two possibilities on what was happening (I think):
1. The slide was cycling too fast due to the hotter HST ammo, causing it to "outrun" the magazine spring. Reducing recoil spring weight causes the slide to return to battery more slowly, giving the mag spring more time to lift the round up.
2. The slide was short stroking due to the spring pressure from the magazine. Reduced recoil spring weight allows the slide to travel to the rear more easily. This is usually what happens with other pistols with really stiff mag springs (my P365xl had this happen occasionally before the mags broke in) which is why I had originally thought this might be the issue.
I think the next thing for me to try is to go up from a 21lb mainspring to a 23lb. If it doesn't cause a problem or makes it even better, then theory (1) is probably correct. If it starts malfunctioning again, then (2) is probably the issue.