Have you tried rocksett?
http://www.brownells.com/gunsmith-to...prod54624.aspx
I have used it to secure suppressor mounts on 556, 300blk, 308 and 6.5creedmore rifles.
Sent from my iPhone using Tapatalk
AKA: SkyLine1
Rocksett is a vibration inhibitor, part of your issue along with heat.
Sent from my iPhone using Tapatalk
AKA: SkyLine1
Make sure the slide isn't hitting the comp as it returns to battery.
Take this with a grain of salt:
You've been shooting it, so you should be able to look at the back of the comp and see if there's marking evidence, it'll look different where there's contact, if there is. Even if the comp doesn't touch the slide in battery, it's possible the slide is hitting the comp as it's closing, before the link swings the barrel into lockup. Keep in mind the barrel tilt. Paper is fine to check it in battery, but ease the slide forward with the barrel pointed up. See if the comp is the first thing the slide touches. It should be the hood. You can also sharpie the back side of the comp and cycle it a couple times to see if the sharpie marks away.
I knocked a comp loose on a CK gun. The ass end of the TI comp had shiny parts where the slide was hitting rather than the blasted surface everywhere else. I ended up filing the back side of the comp (up top where it was touching only) a few thousandths until the hood was the first part that touches. That was back in October I think, still on tight with plane jane red loctite. The gap when in battery is somewhere around 10 thou now.
Loading
Loaded 500 real quick and case guaged 300 of them for a match Saturday.
Tightened my shell plate a hair and ran it fast, does a lot better. Managed 100 rounds in 3 minutes.
Powder funnel need some attention/replacement.
Press
Still need to replace the tool head return spring
Need to mess with powder funnel
Play with shell plate tightness some more
Load more ammo
Chrono
Need to chrono these rounds and make sure I'm legal for area 6.
Last edited by LittleLebowski; 03-27-2017 at 09:39 PM.
i used to wannabe