For those of you who might be looking for an AIWB Rig for a Hi Power. I had checked JMCK's Website and emailed Tony regarding a holster for my Hi Power. He replied that he didn't have a Hi Power and was unsure if a 1911 holster would fit. I studied the photos and decided to try his AIWB Wing Claw 2.5 for a 5 inch 1911 with full body shield and wide spaced 1.5 Pull the Dot Loops and an AIWB High Ride 2 Loop Pull the Dot Magazine Pouch for a Beretta 92. The magazine pouch arrived and all I had to do was set the depth screw for how low I wanted the mag to sit, and tighten the tension screw a bit. When the holster arrived I found that the only issue I had with fit was that the stud of the slide stop/release was binding on the inside of the holster when attempting to holster the pistol. I warmed that spot slightly and inserted the pistol, once cooled I adjusted the tension screw and it works perfectly. I added a foam wedge and the rig rides very comfortably. And my 1911 still fits perfectly as well. You could also trim the tip of the stud as well so it would clear. Hope this helps anyone who might be looking for an AIWB for their Hi Power.