Just returned from the range where I put 100 rounds through a new P365. The handgun ran flawlessly but I’m noticing some wear marks on the barrel hood that I’m unfamiliar with. This P365 is intended as a spare to my primary P365 CCW which has 1,000 rounds through it and zero marks on the barrel hood. I did clean and oil this P365 prior to shooting it.
Should I be concerned?
I've got 3 365 / Xl's with a couple extra barrel's / slide's.
That's more front to back wear than mine show but,
if it runs good, I'd just keep it lubed and run it.
After a while, you could try some cold blue on it
if it bothers you.
Man, that looks gnarly. I know these guns are tight but geez.
Paging @TC215
I've got about 100 rounds (about 50 of 147-grain HST and about 50 of 124+P Winchester Ready Defense) through our P365 and I don't believe it looks anything like that. Will try to get a pic later.
State Government Attorney | Beretta, Glock, CZ & S&W Fan
About 1,000 rounds or more for comparison’s sake. It wouldn’t bother me as long as the pistol shot tight groups and was reliable.
I have some that look like that and some that don’t.Originally Posted by Snidely Whiplash
They all shoot the same. It’s just cosmetic.
You should see the barrel on my competition gun, lol.
I think you have me confused with someone else...I'm certainly no Sig expert.
However, it does look like a lot of wear to me for just 100 rounds.
My bad! You are right, I meant @lwt16. Apologies!I think you have me confused with someone else...I'm certainly no Sig expert.
However, it does look like a lot of wear to me for just 100 rounds.
I feel like you can't just say that and not show it with round count lol
Looks good. Keep on truckin’.
Reply With Quote
