Hello Mr. Tracker. I'd like to thank you for your contributions to the forum! I have enjoyed reading many of your posts about the PX4 series.
What spring changes do you think could be easily done by most end users 'out of the box' without sacrificing defensive reliability? In the spirit of the thread title, I'm thinking in terms of what Beretta could be doing to deliver an improved factory trigger, with readily available parts, if they were ever so inclined to release such a SKU#. Also, could you describe how these modifications would be likely affect the pull characteristics in your experience?
On a side note, I have always struggled with DA/SA guns due to small hand size, even though I prefer the trigger system from a mechanical/administrative standpoint. The trigger is a long reach when decocked. The CZ P07 I used to own was a bit hard for me to deliver the first shot out of the holster when only using one hand. I have long wanted a G model PX4 in 9mm, but I am afraid I would have the same problem, unfortunately. Some day I will own one, but it always falls too low on my list of priorities to make the purchase. However, every time I read one of your posts I check the price!
Thanks again!