It may be some snipping is in the works . . .
https://nordiccomp.com/categories/ex...-tube-springs/
The nordic spring comes with instructions on how to cut it to fit.
Sent from my iPhone using Tapatalk
FWIW If you’re in southern WV the Bridgeport Equipment in Beckley has an OD 1301 as of today for sub $1,300.
I have my 870’s so there you go.
I recently went through this with the extension on my 391. I think I trimmed a fresh spring to 14" extra length and it has been running fine with cheap bulk low brass shells. I had the entire spring in there, and it was a bitch to load.
On a side note, not sure if this is common practice, but the hole in the cap (that I expect is there to drain water?) can take some kind of rod (I use a cleaning rod) through it and through the spring, and it makes it a bunch easier to wrestle the spring into the tube.
Sent from my SM-G892A using Tapatalk
Anyone heard when the CROM might be available again?
Are you loyal to the constitution or the “institution”?
I've been on the notification list for the Crom and the SGA stock adapter for about a year so by this point I'm not holding my breath.
I bought my 1301 in March about the time I wrecked my right shoulder. It's still not healed enough from the surgery to shoot a 12 ga off it but I finally managed to at least have a buddy shoot it to make sure it actually functions!😂 It runs like a top! Hopefully by the time I'm able to shoot again I'll have the gun set up to my liking.
I would rather have questions that can't be answered than answers that can't be questioned. - Richard Feynman
When I give food to the poor, they call me a saint. When I ask why they are poor, they call me a communist.- Archbishop Helder Câmara
Reading fail.
.
-----------------------------------------
Not another dime.