Dillon Super 1050
Mr. Bulletfeeder
Needle bearing kit
Level10 primer support die
TNT Burly Shellplate
Lee U sizing die with Squirrel Daddy decapping pin
RCBS Lockout powder check die
Hornady taper crimp seating die
Lee Factory Crimp die
Dillon Super 1050
Mr. Bulletfeeder
Needle bearing kit
Level10 primer support die
TNT Burly Shellplate
Lee U sizing die with Squirrel Daddy decapping pin
RCBS Lockout powder check die
Hornady taper crimp seating die
Lee Factory Crimp die
Last edited by Clusterfrack; 12-03-2019 at 08:03 PM.
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
7000 rounds. Almost halfway there, but I would be a lot farther along if some asshole didn't keep shooting them up.
Last edited by Clusterfrack; 12-18-2019 at 03:45 PM.
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
Ammo shortages call for drastic measures - it was time for an upgrade.
#RESIST
Someone liked an old post in there thread... New reloading setup is WAY better...
http://instagram.com/p/BuH-o4mHpaK/
http://instagram.com/p/B1SMHl4AT-H/
Still running the Forcht Conversion on the 1050...