Thank you for the informative reply!
I've made good experiences with torque wrenches, have lots of them, also for small torque values. I suppose an appropriate little torque wrench helps with the bottom mounted battery. But I don't have an RMR, don't know yet. A precondition would be of course that Trijicon specifies the correct torque value.
Last edited by P30; 06-20-2021 at 02:41 AM.
They do specify 12 in/lb of torque, IIRC. Battery life at least should be pretty decent.
Part of the reason I got a mix of Holosuns/RMRs was that while RMRs may be more reliable out of the box, the holosun equipped optics shouldn't have an issue with zero shift every time I change the battery, so my reasoning was I could save money by equipping backup pistols with the Holosuns and use them for CCW after a battery change in the RMR when the loctite is still curing/haven't had the chance to confirm zero yet.
My wife loves when I make a quick stop on the way home.
Vacation carry.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
Finally got this project done. Sent the slide to @CHPWS for an RMR cut. Got it back today and switched everything over from the AIM Surplus slide.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
My old-is-new CCW Glock 19. First Glock I ever bought, now fresh back from Maple Leaf Firearms.
Pretty darn busy these days but I get a week off just before my birthday in early september, will zero this then.