Here we go; this is pretty close to what I use, except I do it overhand for better leverage:
Here we go; this is pretty close to what I use, except I do it overhand for better leverage:
The most powerful and harmful influence Trump has had on our politics…has been the effect on his opponents. They have been triggered into an orgy of self-mutilation—eager to amputate their own history and disfigure their own political traditions.
I used to simply operate the slide as I would when chambering or ejecting a round. I've recently found the method @TGS described below to grant a greater level of control over the motion of the slide.
I’ll add another recommendation to the method TGS described. It offers far better control of slide movement vs manipulating the slide similarly to chambering a round so you don’t end up accidentally ejecting a round while doing a chamber check.
I believe the following picture is what is being described, and it is what I do
Another method is to take one’s thumb and hook it under the beaver tail area, then take your index and middle fingers and hook them on the rear sight and use a pinching motion to slightly retract the slide.
Last edited by HCountyGuy; 01-09-2020 at 10:22 PM.
Langdon will show how with a Beretta 92 early in this video https://www.youtube.com/watch?v=5VP4X6FVa4E
Tiger McKee with a 1911 at around the :45 mark https://www.youtube.com/watch?v=UkZgYb-ReSU
The late Paul Gomez with a Glock https://www.youtube.com/watch?v=JU68wjU5b80
Last edited by JTQ; 01-09-2020 at 10:32 PM.
Bill Rapier teaches this method:
For me it doesn't work, as I don't have as big of hands as his.
The below method is the way I check the chamber everyday:
Thumb on back of pistol grip tail, all but pinky fingers on slide, pull the slide back and you can visually see the bullet in the chamber and/or in low/no light you can use your pinky to tactile feel the bullet in the chamber. Let the slide go forward and tap the backplate two or three times to make sure the slide is seated.
Christ almighty, finally a pic on the internet that shows the hand orientation I was looking for. I thought I was going to have to hold a phone in my teeth, or something. Hat tip to @voodoo_man
This pic^^^
Strong hand makes sure the muzzle is pointed somewhere prudent; I use a push/pull scissor pinch, but, yeah, this.
Last edited by Totem Polar; 01-09-2020 at 10:50 PM.
The most powerful and harmful influence Trump has had on our politics…has been the effect on his opponents. They have been triggered into an orgy of self-mutilation—eager to amputate their own history and disfigure their own political traditions.
https://www.youtube.com/watch?v=c0NzEE0kPG8
Skip to 1:19.
Or enjoy the whole scene, it is one of the better ones.
Doesn't read posts longer than two paragraphs.
I'm a bit weird in this aspect too. But since RJ asked, I also chamber check by looking in the gap. I rotate the gun "gangsta" style, pull it straight back to me keeping it pointed safe direction and look for the glint. Sometimes you need to catch the light just right, but it's usually easy. I have never heard of a malfunction being induced by chamber checking, but I personally figure the less fiddlefucking around I do with the round in the chamber and shuffling of the top round in the magazine the better. I also keep in mind DocGKR"s warnings about rechambering defense rounds. I don't know if a press check is a violent enough action to potentially cause primer problems, but with my method it's completely a non issue.