Sorry, just saw this.
The Langdon M9 model comes with flathead grip screws. I like flatheads more because they're harder to round off, and the hole isn't as deep into the shaft of the screw. I changed to stainless to prevent rust, because FL has them against sweat alot.
My Elite LTT came with hex. Because they're stainless I'll probably leave them. I don't dislike hex enough to change them out, just flathead is my preference.
If I ever need to get new screws in the future I'll likely choose flathead and stainless.
-Cory
I picked up one of the Italian Police trade-in Model 81 Cheetahs in .32ACP. Now I just need to find a few spare mags that don't cost almost as much as I paid for the gun.
Last edited by Wheeler; 09-01-2019 at 05:03 PM.
Men freely believe that which they desire.
Julius Caesar
"When the phone rang, Parker was in the garage, killing a man."
^that c and c barrel looks great. I will try to do that on my ltt compact.
This started out as a 96FS Vertec, then it had a D Upper in in 9mm, now it's got a standard 92FS upper with a G conversion and M9A3 grips. Think I'll keep it this was for a bit.
LTT Elite Centurion on the woodpile:
My introduction to Beretta-world a few years ago. 92A1 and a PX4 Compact, both with lighter springs, performance parts, etc. I eventually sold them both after deciding that the Langdon Tactical guns have everything I want right out of the box, and modifying the factory guns myself just wasn't worth it.