Just curious who everyone is using these days. My 2 gen 5 G17s have enough rounds through them to justify a voided warranty so I'm looking to get them milled for the RMR footprint. Thanks.
Just curious who everyone is using these days. My 2 gen 5 G17s have enough rounds through them to justify a voided warranty so I'm looking to get them milled for the RMR footprint. Thanks.
To me, slide milling for a red dot is like body armor - I’m not about to pay to try something new and untested. ATEi is as tested and proven as there is.
I actually cheaped out and went with the universal cut and am still extremely pleased. I don’t beat the shit out of my guns but I’ve broken plenty of things and mine has held up perfectly.
Sent from my iPhone using Tapatalk
Last edited by Wake27; 08-20-2019 at 08:36 PM.
I have been using Primary Machine with complete satisfaction. They usually turn a slide in a week.
Likes pretty much everything in every caliber.
Wright Armory in Mesa, AZ has done 2 HK VP9s for me a couple of months apart. Turnaround less than a week on both.
The first indication a bad guy should have that I'm dangerous is when his
disembodied soul is looking down at his own corpse wondering what happened.
L&M is one of the originators.
There seems to be a lot of good options for optics cuts.
I took a risk on a local guy that was recommended by a DFW area shooting group: Vulcan Machine Werks. So far, so good.
David S.
I’ve had Vulcan, L&M, Primary Machine and all seemed good to go.