@03RN
Was the pin easy to drift out for the front sight? What did you use/do? How was putting the sight on and replacing pin?
No, apparently Smith uses a super tiny pin. I bought the smallest punch and drill bit (1/8" I think) and it was to big so I just drilled it out and replaced it with a 1/8" roll pin I had.
Glad the drill bits came in a 2 pack because I broke one. Might have been easier with a drill press.
Damn. I’d mess that up for sure. Lol
I wonder what the pin size is.
Sent from my iPhone using Tapatalk
Last edited by newyork; 07-21-2019 at 07:33 PM.
What was done to repair the detent?