Time for a hashtag! #BallerReloading
Bert Gummer is my spirit animal
I want a running commentary, like a play by play.
But for reals I'm jealous, that's a killer setup.
Semper Gumby, Always Flexible
Per requests - a longer video from this weekend's activities.
Saturday night I reloaded and case gauged about 3100+ rounds solo and Sunday AM a buddy and I loaded 1700- more.
On the solo run I was pretty effectively loading on the 1050, filling primers and case gauging all in parallel. I did struggle a good while with priming issues, for some reason the press gets moody and primers aren't getting installed. I haven't figure this new issue out 100% yet and yes I've cleaned everything and replaced the blue tip on the primer feed tube - twice.
Last edited by GuanoLoco; 03-27-2017 at 10:51 AM.
Are you now, or have you ever been a member of the Doodie Project?
How is the Nobel working out?
Sent from my iPhone using Tapatalk
AKA: SkyLine1
The price is definitely right and availability seems good. It burns very clean, comparable to ETR-7 aka (I think) Maxam CSB-1. Also, low smoke and temperature stable.
Down sides:
- It is a rough granular powder with lots of different granule sizes. They are small enough to pour through a flash hole and make a mess if your press fails to insert a primer. This happened a LOT this weekend and is a new issue. In this past priming has been a very reliable operation for me. Larger flake powders do not have this problem. It is dense enough that it doesn't tend to fly out of cases very easily.
Metering: It has weird settling issues, perhaps caused by the irregular granule size. When I started I was doing 20 throw sets and weighing (3.7 gr x 20 throws - 74gr). After 2000 rounds I checked and the throw had increased to 76 grains! I am used to my final check being VERY stable with ETR-7, which is a round flake. I re-calibrated (I am using a micrometer on the powder bar) and after another 1000 rounds I re-checked and it had crept up AGAIN to about 75.0.
The next day I re-calibrated before loading and loaded 1700. This time the check after loading was down to 72.4 grains.
My target power factor is currently 132 (I need 125+), so I am fine with that but it is irritating.
When I look at the powder measure there definitely seem to be layers of larger and smaller irregular granules. Perhaps shaking up the 0.5 kilo / 1.1 lb powder jugs before pouring them in the powder measure would help. I'll try this in the future.
Last edited by GuanoLoco; 03-27-2017 at 11:17 AM.
Are you now, or have you ever been a member of the Doodie Project?
Looks like cat litter, did you let Luke in your shop?
Thanks for the news on the powder. I'm currently loading with CFE Pistol.
Sent from my iPhone using Tapatalk
AKA: SkyLine1