432UC
A cylinder at 25
A cylinder at 50, using cover hold.
Ran 20 rounds over the chrono. Not pleased with the velocity spread and SD. May have to accept that it is what it is, based on powder density and type. May have hava bit too close, and sun may have played a role in some errors. Need to borrow my buddies Garmin.
Participation does not equal Proficiency
- Mike Pannone
I was getting a lot of misfires today. So long wilson mainspring.
Looks like I got fat this winter too
On the ragged edge of the world I'll roam,
And the home of the wolf shall be my home - Robert Service
More rounds through the 432UC. I'm at just over 350 now.
Some of my better work at 25yds. Grip consistency is key.
Almost..
Participation does not equal Proficiency
- Mike Pannone
30yds, 10mm full power loads
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
I've discovered that heavy mag springs and mag shims from https://460rowland.com are required for 100% reliability in Glock 20s and full power loads. I'll update this post later with a link to the PF thread about that.
Last edited by Clusterfrack; 04-18-2024 at 10:03 AM.
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
My new m1903a3. At 200 yards off a stump I'm keeping them in 3moa. That's with my generic m2 ball reloads. I'm hoping for a little better with either 150gr interlocks or 165gr gamekings.
On the ragged edge of the world I'll roam,
And the home of the wolf shall be my home - Robert Service