Question for you M&P folks out there.
I just installed the Apex AE trigger in my early (2007) M&P with the Apex TRS and now the trigger bar isn’t engaging the sear enough to release it. A quick google led me to a 9yr old video from Apex showing how to open up the loop of the trigger bar to increase the engagement sufficiently to release the sear. This was the first time I’d ever heard of a need to do any tinkering/tuning on Apex parts and everything else in the gun dropped right in as expected. Am I just not paying attention, or is this an expected adjustment when adding the trigger? The striker block, sear and associated springs were already in the gun with the original trigger and it functioned fine. I’m ok making the adjustment to the trigger bar, just wasn’t expecting to have to do any tuning with the Apex stuff. I figured I should seek some advice before going ahead with it in case I’m missing something. I don’t want to end up with any doubts about this gun since it’s been completely reliable for me for a long time. Thanks.