JHC recommended the Ameriglo GL-5353 and I just received them from Midway and installed them on my 19 MOS with an EPS on a DPP plate. Heights are perfect.
Likes pretty much everything in every caliber.
Hi, could you recommend plate for Glock 17 MOS to install EPS, that would be reliable and the thinnest as possible? I have 4.5m/0.18inch front sights (measured from the slide to center of sight) - will it be visible or do I have to replace it? Witch my current reddot Vortex Venom sigts are not visible, just precisely on the bottom edge of it...
Anything better then already linked DPP Titanium? Thanks.
EPS cold test-pass. Let it set out for an hour while walking the dog. Shake awake turned on, shot 1 mag of 20 for a total of 7400 rounds since mounting. I used Prematex gasket maker between the slide-plates-sight still tight and zeroed.
I can now confirm that the following is a replacement for the EPS and EPS carry battery tray screw:
Black-Oxide 18-8 Stainless Steel Phillips Flat Head Screws, M2.5 x 0.45 mm Thread, 5 mm Long, Packs of 100
https://www.mcmaster.com/catalog/91698A241
4mm should fit as well.
@RJ maybe add to the QR card?
@GJM
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie