Looks good, haven't mounted anything and shot it yet. Total bill including shipping $324, turn around 4 weeks
Looks good, haven't mounted anything and shot it yet. Total bill including shipping $324, turn around 4 weeks
Looks clean! What optic?
Ken
BBI: ...”you better not forget the safe word because shit's about to get weird”...
revchuck38: ...”mo' ammo is mo' betta' unless you're swimming or on fire.”
his RMR plate, I am mounting a 407CO on it
I wonder if they can do an EPS plate with lower sights… hmmm.
It looks like they didn’t refinish the entire slide - correct? That’s something I’m trying to avoid.
Ken
BBI: ...”you better not forget the safe word because shit's about to get weird”...
revchuck38: ...”mo' ammo is mo' betta' unless you're swimming or on fire.”
It looks as if the rear sight is integral to the plate, which sits between "ears" of the remaining slide?
Participation does not equal Proficiency
- Mike Pannone
Correct, no visible refinishing.
They told me that because of the HK lightening cuts it was only possible to employ 3 of the 4 screws they use when they mill some other slides for this type of plate. Not enough metal to make use of the 4th screw hole where it is placed in their plate. I say no big deal, most plates are held on with only two anyway.