Radian Weapons Afterburner / Ramjet - Glock 19 Barrel and Compensator

[JCN]

Will the Ram-Jet work on this Brownells G-19 Gen-4 slide?

Looks like it works.

[JCN]

@HeavyDuty

Dremeled an ambi release cut in a Gen 3 slide to use on a Gen 5 frame.

[JCN]

I might trim the 17 dust cover.

[Simong]

Looks like it works.

Thanks for the info, ordered.

Simong.

[Lon]

I might trim the 17 dust cover.

Have you done anything else to that 17 frame to get the 19 slide to work?

[JCN]

Have you done anything else to that 17 frame to get the 19 slide to work?

No, I’m dumb and didn’t realize the rails were in a different place. When I ordered the frame I should have ordered a G45 frame. Doesn’t work so I ordered a Gen 5 G34 barrel so I can use a Gen 4 slide after swapping back plate.

[Lon]

No, I’m dumb and didn’t realize the rails were in a different place. When I ordered the frame I should have ordered a G45 frame. Doesn’t work so I ordered a Gen 5 G34 barrel so I can use a Gen 4 slide after swapping back plate.

Gotcha. Was hopeful you knew something I didn’t. I’d love to be able to make that work.

[JCN]

Gotcha. Was hopeful you knew something I didn’t. I’d love to be able to make that work.

I could make it work by cutting and moving the rails posterior but not worth the cost and hassle, I think.

Still debating whether I should order a G45 frame as well (probably).

[JCN]

With flashlight and heavy mag, I don’t feel like I’m giving up much performance to my normal CO gear.

The pause on entry at the first position was to foot sweep the activator rope (which is why I didn’t enter the position with gun mounted).

[Simong]

Looks like it works.

Got the kit on Monday, installed looks and perform very well.

Thanks again.

Simong.