Can anyone who has a TLR-7 Sub for the P365 confirm this is an old attachment method? I remember someone ( @JCN ?) Saying they were updated at some point. This one slides around and wobbles no matter how tight the screw is.
If it rocks fore and aft, have them send you the updated one. They’ll do it free of charge.
Here is the contact info:
cs@streamlight.com
Attention:
Mark Carson
Service Department Manager
610-631-0600 Extension
Hello, my TLR-7A has a lot of wobble and it’s damaging my rail. Could you send me the new clamp jaw part?
My SN is Xxxxxxxxx
There was some discussion about mags rusting, I can confirm that it can happen even in Wisconsin. My (USA) carry 15 rounder.
Agreed wax is a good inexpensive solution for mag bodies. Has anyone found a coating that sticks to the safety lever? I had mine all coated the same as my mags. The mag bodies have been holding up really well but I wore through the coating on the safety lever, and am seeing rust develop by the end of the day. I hate having to oil it to clean it up every time I spend any time outside or working on projects. I wish I could get Certum's from Tenicor with a full sweat shield. I feel like the finish would hold up like it has on other stuff if it wasn't rubbing directly against my body all day. I love the 365 series but the coatings Sig is using suck.
My P365 mags rust worst than any other Sig part I've seen and I've seen a lot...
- It's not the odds, it's the stakes.
- If you aren't dry practicing every week, you're not serious.....
- "Tache-Psyche Effect - a polite way of saying 'You suck.' " - GG