Any more info on the new GGG mount? Links?
Any more info on the new GGG mount? Links?
I’m curious why LTT switched some products to GGG? Parts availability possibly?
Nailed it! If I hold the charging handle I no longer hear the noise of the sprigged mechanism letting loose. So, it was the bolt carrier moving slightly to the rear when I slammed the buttstock, then going forward. Which sounds obvious, but I didn't expect the giant spring to be weak enough to allow it to move when I did that. Lesson learned!
"Follow me!"
I haven’t tried it.
The Blitzkrieg and the XS front sight are a full 1/8 taller than the OEM front sight.
Sighting is dependent on how you mount the gun, your cheek weld, vision, and preferences.
For me, with the red dot off, irons only, I ran out of elevation with the standard CROM aperture. When raised to the preferred height there isn’t enough stem for the set screws to engage.
Are you loyal to the constitution or the “institution”?
I've probably got 700+ shells through my 1301. After this last session of over 100 shells I was not able to clean it right away like I would normally. A week later I went to clean it and had to use a soft rubber mallet to remove the barrel. When I did, a rubber o-ring fell from the piston assembly.
The O-ring is part# C5A038.
I'm curious if those of you who don't religiously clean your 1301 like I normally do, have had this o-ring fail when disassembling the shotgun? I don't believe it's 100% required to be in place for the shotgun to fire, but I'll be looking to get a replacement ASAP. Though, I'm a bit disappointed to have an expendable o-ring within the gas system.
EDIT: Looks like Freedom Fighter Tactical is the only US store with these in stock. it's 2x the price ($15) and shipping is $20. Anyone know a better place? Brownells and Midwest don't have them in stock. Beretta USA doesn't even have them listed.
Last edited by trajiiic; 07-11-2022 at 01:38 PM.
"Follow me!"