It is possible to re-use the flange tool? To uninstall/reinstall the adapter a few more times?
It is possible to re-use the flange tool? To uninstall/reinstall the adapter a few more times?
Not many. However, I like the knowing I have the tools to remove/reinstall it if necessary.
On another tangent: I also notice how the adapter is scratching up my right hand, slightly above the web between thumb and index finger, when putting the rifle on safe. I would go as far as to say that ambi safety is strongly recommended with the LAW folder.
It will work a second and probably a third time if need be.
As far as chewing up your hand, that is something noted earlier in the thread by at least one person. I think it depends on how much you rotate your hand to activate the safety. I don't have that issue, but my wife did. I think the person in this thread filed down the ledge that was causing it.
@Andy T
Law Tactical offers "Replacement Parts + Tools" on their website.
https://www.lawtactical.com/category_s/1818.htm
The Flange Tool is currently listed at $3.99 each.
And they offer an Armorer's Flange Tool at $45.99 each.
Well, my LAW folder is finally on the way...
Sportsman’s Outdoor Superstore shipped the one I ordered 2 weeks ago today.
So I canceled the one that’s been back-ordered from Optics Planet for a month.
I’m really disappointed in Optics Planet. They showed it on their website as if it was an in-stock item, and then changed it to backordered the next day, after I had ordered. Then did it again about 10 days ago (although I called & chatted to verify whether it was in stock). After spending an hour trying to get an attendant to answer, it changed to “back ordered” again.
The one from Sportsman’s cost a few bucks more, but at least it’s not vaperware.
This has been a good thread, thanks to all who have participated.
I need a pair of these. One for a 11.5" pistol, the other to swap out the Maxim PDW stock on my DD PDW (want to get it even smaller).
I've signed up on couple email lists, so it's just a matter of waiting.
I guess I need to email LAW and see if they have a solution for a 10.3" DI gun with an H3 buffer.