Caleb strikes again

[Chuck Whitlock]

I have a twin to the one in the first picture, except it sports an orange XS sight (green was OOS) and the factory rubber grips. A set of UM boot grips should be delivered today.

That's better.



I will need to dress the rear corner, which is a little sharp.

[revolvergeek]

Sent from my iPhone using Tapatalk

I have been debating ordering a pair of those grips to check out. I currently have Uncle Mikes Boot Grips or Eagle Secret Service grips on all my little Taurus pocket revolvers. Those look like they would be perfect on the UL380.

[Noah]

[MENTION=67]jetfire[/MENTION] I’ve been hoping for a K frame “Roscoe”… is that something we’ll ever see? Unshrouded ejector rod, wood grips, same finish as the current guns?

[CarloMNL]

[MENTION=67]jetfire[/MENTION] I’ve been hoping for a K frame “Roscoe”… is that something we’ll ever see? Unshrouded ejector rod, wood grips, same finish as the current guns?

I suppose they could make it happen if there's enough demand. Sort of. I don't think they have a true K-frame sized revolver. The 82 takes K-frame speed loaders but is more L-frame in size. FWIW, the Taurus 82 with a full length underlug seems to be an American SKU. I've never seen one here as all we get are half shrouds and unshrouded ejectors rods.

https://taurusarmas.com.br/pt/produt...-082-cal-38spl

https://taurusarmas.com.br/pt/produt...2s-cal-38spl-1

[jetfire]

[MENTION=67]jetfire[/MENTION] I’ve been hoping for a K frame “Roscoe”… is that something we’ll ever see? Unshrouded ejector rod, wood grips, same finish as the current guns?

I would very much like to import the South American market 82 in a deep blue finish Ala the Roscoe and call it the Stakeout

[Noah]

I would very much like to import the South American market 82 in a deep blue finish Ala the Roscoe and call it the Stakeout

Love it!

[Buckeye63]

I kinda wish Taurus would had built the Roscoe on the 856 frame instead of the 85/605 ..frame..
I own two Taurus revolvers.. both are good to go

[lee n. field]

I kinda wish Taurus would had built the Roscoe on the 856 frame instead of the 85/605 ..frame..
I own two Taurus revolvers.. both are good to go

Nostalgia says, "5 shot .38".

Maybe someone could make a pin on half round front sight.

[RevolverRob]

Nostalgia says, "5 shot .38".

Maybe someone could make a pin on half round front sight.

$1 coins usually work.

Remove the old one, measure the height, make the top of the radius even with the max of the ramp, use a punch to mark the pin hole, drill, chop the coin the to match the bottom of the sight with a Dremel, insert, pin.

@Flamingo might have something in his safe wearing a half a 'gold' $1 coin as a front sight...

[Buckeye63]

Nostalgia says, "5 shot .38".

Maybe someone could make a pin on half round front sight.

Colt Detective ? Not much more nostalgic than that 🤣
856 uses same holster as the Colt