Oh. That.
Will you allow another attempt at describing the situation?
I was doing my daily dryfire when I suddenly could no longer rack the slide to prep the trigger for the next dryfire. Some time ago the same symptoms appeared and it was determined (IIRC) that the locking block was the issue. It was resolved by, again IIRC, replacing the frame. The frame now on the gun is G1689 US. You might find it in your records, if you wished to look.
I was on day 2,333, with a sum of 116,500 dryfires when the mishap occurred. I do not remember whether I began the count a “zero” when the original frame was replaced, so this information might not be of service to you.
So. Is there a way I can send the pistol back to the mothership for repairs?
* * *
From: James "Abe" Race <James.Race@glock.us>
Sent: Wednesday, April 10, 2024 4:47 AM
To: gary_crumrine@charter.net
Subject: RE: Slide fails to cycle
Good Morning,
When you are dryfring the slides do not cycle like they do when shooting. You have to rack the slide each time.
-Abe
With kind regards,
James Race
Technical Service Representative
* * *
From: gary_crumrine@charter.net <gary_crumrine@charter.net>
Sent: Tuesday, April 9, 2024 1:03 PM
To: Technical Service <Technical.Service@glock.us>
Subject: Slide fails to cycle
Sir,
My G-19’s slide failed to cycle during today’s dry fire session. Is there a way I can send the pistol back to the mothership for repairs?
Cordially,
Gary Crumrine