Rexio Pucara 383

[EasyTargetRN]

I recently acquired this revolver and, once cleaned, took it to the range and found I'm getting light strikes. It's an Argentine S&W J frame copy but the internals are quite different. I thought, at first, it might be due to the transfer bar not rising enough to interact with the hammer. After further research, it may also be end shake but I've yet to measure.

Parts are practically non-existent so I'm looking for any insight from those that may be familiar with this revolver.

Thanks in advance

[EasyTargetRN]

On further inspection I found that the face of the transfer bar had been dimpled, by the firing pin which seems to be causing the light strikes. I fashioned a "shoe" from thin brass to see if it would make better contact but it also resulted in binding the cylinder release. If I cannot find a transfer bar, what are some options?