As thin as Talon rubber is, it makes my Plastic M&P feel bulky. If there were something that would not lift at edges, I would just tape the front strap.
It is fine on the little G43.
As thin as Talon rubber is, it makes my Plastic M&P feel bulky. If there were something that would not lift at edges, I would just tape the front strap.
It is fine on the little G43.
Code Name: JET STREAM
Try TractionGrips. They are thinner material, and I use the procedure below to apply and have had no peeling even after years of use.
- Clean grip with rubbing alcohol and dry thoroughly
- Warm grip and decal with hair drier
- Start applying decal by aligning with the mag release hole (the most important spot)
- Slowly apply the rest of the decal, smoothing out any bubbles
- Warm again with hair drier and adjust as needed, then apply pressure evenly
- Let cool
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
Thats an LTT gun, comes with the laser stipple and undercut.
https://langdontactical.com/custom-g...glock-pistols/
Talon grips are the “good” option for me. An LTT stipple and undercut is the “better” option. A Boresight duty series with Razorback is the “best” for me.
Priced accordingly of course.
Oh, thought they just do the laser part. Nice work.
Gaming will get you killed in the streets. Dueling will get you killed in the fields.
-Alexander Hamilton
I’ve had good luck with Talon grip tape from Brownells. As someone mentioned here, make sure to degrease and then heat the surface before applying.
Sent from my iPad using Tapatalk
Cut a piece of mountain bike tire tube to fit. Ugly but effective.
Do unto others as you would have them do unto you.