Results 1 to 4 of 4

Thread: New P365XL Optics Ready with 407K interference with JMCK IWB #3 holster.

  1. #1

    New P365XL Optics Ready with 407K interference with JMCK IWB #3 holster.

    I have a JMCK IWB #3 for a P365 I purchased a while back. I ordered it with a red dot cut, but Iíve been using it with a non red dot equipped pistol.

    I recently picked up a P365 XL Optics Ready pistol and mounted a Holosun 407K. Immediately I noticed the edge of the 407K has an interference with the edge of the holster.

    I assume the older design of the P365 XL, where the optics cut replaced the rear sight, the optic would sit farther back and this interference would be a non issue.

    My intuitively plan is to use sone fine grit wet/dry sandpaper and slowly remove material until the optic has clearance to the edge of the holster?
    Attached Images Attached Images  

  2. #2
    Site Supporter Tony Mayer's Avatar
    Join Date
    Jan 2012
    Location
    Bells, Texas
    That will work, or we can send you a label and take care of it for you. If you want to do that, email me at sales@jmcustomkydex.com

    Thanks
    sales@jmcustomkydex.com

  3. #3
    Quote Originally Posted by Tony Mayer View Post
    That will work, or we can send you a label and take care of it for you. If you want to do that, email me at sales@jmcustomkydex.com

    Thanks
    I appreciate the offer greatly, but this mod was well within my very limited skills. I sat down this evening and a few minutes with a coarse file and then a little more with some wet/dry 600 grit and the interference is gone. Now the Holosun equipped P365XL locks firmly into place.

  4. #4
    Member
    Join Date
    Dec 2021
    Location
    Idaho
    Quote Originally Posted by Tannhauser View Post

    I assume the older design of the P365 XL, where the optics cut replaced the rear sight, the optic would sit farther back and this interference would be a non issue.
    As you suspected, the red dot sits much further back on the slide of the older 365XLs. I just checked mine and itís less than 1/4Ē from the rear of the slide.

User Tag List

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •