Finally bought one of these for my non-Glock Glock project. It’s a pretty nice slide for the $$. There is a paper thin gap in between the back of the Holosun and the slide. But with the raised bosses I’m not worried about it. GL-429s are on order.
Family photo:
L to R: 19.5, 19.4, 19.3, SCT/Remsport non-Glock, G44
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
0.145”
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
Fantastic, thank you. About same as my Aim Surplus slide, but better in that it has bosses.
Problem now, I search for them, and it's as if TR Enabling's site is down.
ETA: NVMND, it's back up.
GL-429s are in.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
Don't know how they'll do on that slide but on my Glock slides, GL-429s hit several inches low at 30-45 feet. I can aim at the top edge of a 3x5 card at 30 feet and rounds will hit at or just below the bottom edge of the card. The max I usually practice/shoot at is 45 feet and there's not much of a change in POI. This is on both a G19 and a G17, with 147s...factory sights btw will hit just about exactly at point of aim. I have NOT tried the sights at 25 yards...but I don't think that there will be several inches of difference at that range?
https://www.combatarmory.com/combat-...black-nitride/
https://www.combatarmory.com/combat-...black-nitride/
I ended up ordering this. I bought one of their Blem Frames a few months back for $39…. Got a threaded barrel on sale for $35…
It may suck. But when the parts were this cheap, I decided to roll the dice.
Sent from my iPhone using Tapatalk
“A gun is a tool, Marian; no better or no worse than any other tool: an axe, a shovel or anything. A gun is as good or as bad as the man using it. Remember that.” - Shane
That’s a good looking slide from the pictures. Be interested to see how the optic fits down in the cut and what kind of gap there may be. I just got an AIM G17 slide. It’s a really nice slide, but I’m not thrilled with the amount of gap left after the sight was mounted. I tried 3 different brands (Trijicon, Holosun and Swampfox) and all had a gap. Since there aren’t any raised bosses, I worry about sheering a screw off.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
Ok...be gentle...
Googled and came up with “yes” and “no”.
Can a Gen3 slide be used on a Gen 5 frame?
I have a POW that I’d like to experiment with. Would rather not cut the slide. It’s a Gen5 G19.
Thanks
Working diligently to enlarge my group size.