MolyResin got brought up in another thread, but I didn’t want to get off topic so I decided to start this one. I used The stuff a lot 10-15 years ago, but the haven’t heard about it much lately. I guess most people are going with AceraKote now?!?!?

I really liked MolyResin because with the right equipment, you could do it at home. I had an air compressor, air brush, blast cabinet and an oven and I was good to go. The stuff went on really thin which I really liked.

I’ve also used Alumahyde with good results, but it goes on thicker and requires a week to air dry.