Trigger pulls at 4.5# at the bottom of the trigger (have video). I tried 3 guns in the store, and the other two had a little stacking in that little space between the "wall" and the break.
The mag-springs must be super strong because I can't close it on an empty mag with my thumb (but it's super easy with no mag & easy with a round in the mag).
The OEM sights are barely visible--I really wish they were high enough to see 3/4th to the full-depth of the rear notch. My hope is that the aftermarket will finally come out with 365 "optic height" sights that aren't too short or too tall, and that someone will come out with a non-LCI notched barrel that might help reduce smoking up the lens.
I was surprised how small the grip is...I was expecting it to be a bit longer. The backstraps really let you find a nice sweet spot for space for your support hand.
LOTS OF RANDOM PICS:
Last edited by evi1joe; 08-14-2022 at 08:07 AM.
Sure.
I'll post one up when I get back--it may be awhile.
But these two pics of the XL grip vs the X-Macro may help for now:
Two things extractor and LCI related. I don't understand why all or most manufacturers don't use the pivoting type extractor design. It allows for lower optic mounting,can work as a loaded chamber indicator and uses one less part than the Glock plunger type extractor. This is even more important now that optics are so standard since lower optic mounting and no notched barrel LCI allowing debris to get on the optic lens and LCI being required in some locales. It seems like a no brainer. It shouldn't be too hard to add or subtract a little material on the extractor or slide to allow the extractor to act as a LCI and a better one at that since it is functional without looking at the gun in total darkness.
Anyone know the best place to get a complete p365xl slide?