Does anyone have any experience to share finding from retention (high pectoral index as Craig teaches it) with one of these attached? Would very much value that feedback.
Sent from my iPhone using Tapatalk
Does anyone have any experience to share finding from retention (high pectoral index as Craig teaches it) with one of these attached? Would very much value that feedback.
Sent from my iPhone using Tapatalk
A57460
CTC lasers : Pistols = ABS : automobiles
So it's having no problem or signs of trouble ejecting at all? You suspect that the slice velocity is too fast during the forward motion?
Does this pistol sport an optic? It's hard to be certain without taking some high speed camera footage side by side w/ the stock barrel alongside the problem comp/barrel/load.
https://pistolwizard.com/static/img/...pring-7-18.mp4
15 would probably be a good compromise with still enough power to return the slide but just a little less stiff to allow some margin.
https://www.ebay.com/itm/17340564593...id=26042429185
What is the factory spring weight? I've seen recommendations to go no more than 3 lb. below the factory with Glock. Therein lies the true problem, IMO. One spring I do not want to ever mess with in most carry pistols is the one that sets off the firing pin. I feel many are overoptimistic when it comes to downloading those springs to lighten pull weights, sure they work under ideal conditions but I feel the factories build in the extra strength knowing you can't ever guarantee ideal conditions.
https://pistolwizard.com/guides/barrel/compensator#tuning
I have two identically set up 19X/45 with PMM’s dual port. With stock recoil and striker springs both exhibited the exact same malfunction GJM described when running the stock recoil spring and standard pressure ammo of all weights (incl HST/GD standard pressure). 15lb recoil spring assembly from NDZ (still stock striker) resolved all issues and I’ve run 20+ matches with the set-up. If I was planning to run +P I’d go back to stock spring.
Anything I post is my opinion alone as a private citizen.
Here is another Radian Afterburner Ramjet Glock Comp review. I currently have one of these on my Gen 4 based Shadow Systems MR920 pistol, and like in the review mine has also been 100% reliable with the ammo I have run through mine. I am pretty sure we will probably see these available for the Glock 43,43x and the Shadow Systems CR920 pistols at some point, since they all have the same barrel length. I think we may also see one for the standard 3.1" barreled Sig P365 and maybe the P365XL version also. FYI, there barrels have no LCI machined into the barrel hood, which great helps with carbon blow back on your pistol optic lens.
https://youtu.be/7A-NWdEKK1k
Last edited by Biggy; 08-14-2022 at 04:52 PM.
I really want to try one of these. A Gen 3 on my Brownells slide. Then I’ll do a side by side comparison between the Ramjet and the PMM Ultra JTTC.
Now I gotta save my pennies.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com