Hoping this post hits Tony's radar but I'll welcome input from everyone.
Last fall I received an IWB 3 and a couple of AIWB High-Ride magazine pouches. Love the holster, it's super comfortable and does a great job concealing the P365. The pouches are great as well but a slight mod would make them even better.
I ordered the holsters and the pouches with DCCs. It's my first time using them and overall I really like them but the combination of the DCC and the overall short length of the P365 magazines is causing me a problem. The magazine is so short that it rides lower than I'd like but I can't raise the screw/stop to the top hole because of the clip. See first picture below. I'm thinking about drilling my own hole above the factory hole and out of the way of the clip...basically where the green dot is in the second picture. Any concerns or issues with doing so? I can't imagine there would be but wanted to check before getting out the drill.
Thanks