Another New Holster For My 617 With C-More Sight

[AzShooter]

I'm putting my C-More Railway back on my 617 revolver and need a new holster with the front cut low enough for the mount. I use my standard design but changed my dye a bit to get a lighter color. For some reason the dye I've been using is now too dark so I mixed it 2 to1 with alcohol and get the results below.

I tooled the flower. It's my third tooling so I still have a lot to learn but I'm getting there.

I had the holster finished and when I went to put the gun in it didn't fit. The welt I was using was too wide so I had to take the holster apart, trim the welt some and then re glue and stitch it. Fortunately it didn't take too long. I do all the stitching by hand.

All comments are welcome.