Holosun EPS & EPS Carry - Enclosed 407K/507K

[WobblyPossum]

Any idea what the height is of the taller front? I have a 507k on a "X" that it's notch isn't very usable either.

Nope.

We were told we couldn’t let guys with POW p365X use optics due to a POI /BUIS issue.

We were recently told SIG provided our national armory with the correct height front sights to correct the issue and to send in the slides of 365X users who wanted to use optics.

I would call SIG LE customer service.

The new front sights are 0.245” tall.

[Up1911Fan]

The new front sights are 0.245” tall.

Thank you. Have you used one with a 507K by chance?

[WobblyPossum]

Thank you. Have you used one with a 507K by chance?

I have not. No one in my office is carrying a P365X and, even if someone was, the Holosuns aren’t authorized.

[Up1911Fan]

I have not. No one in my office is carrying a P365X and, even if someone was, the Holosuns aren’t authorized.

Copy that, thanks.

[HCM]

The new front sights are 0.245” tall.

[vandal]

Just got the EPS for my 320. Good job Holosun shrinking the 509T. The glass is better than my 509T which still had some distortion at the edge. The EPS is completely clear and flat, no detectable magnification or distortion.

[Tokarev]

Sent from my SM-G970U using Tapatalk

[JCN]

I’m happy that I just sent out a few guns for K series milling, including a 357 Sig Legion P229…

This is a prime candidate for it.

[Kanye Wyoming]

I’m happy that I just sent out a few guns for K series milling, including a 357 Sig Legion P229…

This is a prime candidate for it.

May I ask who’s doing your P229 milling?

[JCN]

May I ask who’s doing your P229 milling?

SAS tactical

I’m not sure if I would pick them again, their lead time is months.

That being said, they have have done Legion milling before and I wasn’t planning on using it this Winter….

Mine should be back in a month or so, I’ll post up when I get it.