It was just stuff I didn't ask about. I just reread the email and it isn't as bad as I remembered. I was looking for more of a quote and not just a price list.
Here's a bit of good news:
https://xssights.com/products/r3d-ni...howHidden=true
Sent from my SM-G970U using Tapatalk
Just a FWIW on one Springfield SA-35 pistol in the 5K serial number range. I don't have a YouTube channel, so no thousands of rounds, or mud and sand torture tests performed by an expert. Just average guy recreational use at the range. I'd guess I have 500+ rounds through my completely stock SA-35 now. No reloads tested, but I'm up to 9 different types of factory ammo used at this point. I have also used several different Hi Power magazines; FN, SA factory, and 13 and 15 round Mecgars.
No malfunctions of any kind thus far. I have noticed that the SA-35 extractor and mag release springs are much stouter than the same springs on my FN guns. Perhaps why I've not experienced any of the failure to extract and/or magazine dropping issues that have been reported?
Your slide doesn't have the Springer logo or the big SA-35 markings on it. Did they drop those from later production guns or move them to the left side?
Bart Noir
The number one cause of reloading guns is missing the target.
Or perhaps the markings are only on some custom factory versions?
Bart Noir
Aren't all SA-35s roll marked like mine?