Might seem like a dumb question but how are X300u carriers retaining the cotter pin, or keeping it pushed up/out of the way? I initially removed it but found that I was actually accidentally popping the battery latch during handling (when pushing the tab for momentary on, you can hear the latch snap shut again)...so I put some tape on it to keep it in and flat against the body, but that's causing some issues, too. Very specifically with a Bawidamann Gotham holster, but also a little bit with a Phlster Floodlight. I made some adjustments to taping it, but I'm kind of looking for a goldilocks solution at this point...any ideas?
If I just leave it as it is (without any retention) it sometimes pops out, and does not stay flat...and reholstering with it not laying flat/partially out leads to all kinds of problems.
Old tape (and you can see how it was causing issues):
Redoing the tape to this way (different gun but both were having the same issues in the same Gotham and Floodlight holsters):
The redone way seems to work better/slicker but I'm still wondering if there's a better way..