MOS plate gap?

[Yute]

New to the MOS plate system and wanted to check. Is a very slight gap between the plate and front and rear of the slide normal?

Tried the Acro CHPWS plate and TD plate and both seem to have it, the former on the back and the latter on the front.

CHPWS:


Tango Down:


Thanks!

[Wake27]

Can’t speak to those plates but it is not present in the FCD version.




Sent from my iPhone using Tapatalk Pro

[Yute]

My understanding is the FCD Acro plate is the same as the TD plate; not sure if there are dimension changes with FCD RMR plate.

[Wake27]

My understanding is the FCD Acro plate is the same as the TD plate; not sure if there are dimension changes with FCD RMR plate.

You’re right, forgot they did those with TD. Send FCD an email, Roger is always on top of answering stuff like this and fixing it if it is not intentional.


Sent from my iPhone using Tapatalk Pro

[FreedomFries]

I have 4 MOS pistols and the same plate can be snug and press fit into the slot on one but have very slight movement on another. So your small gap does not sound unusual to me. I measured with calipers and did find some variablility in the cut, but I did not write down the measurements so I forget how much they differed by.