OK my quest for knowledge continues.
BTW mods, if this better belongs in the RDS forum, please move.
I'm trying to join the ranks of the pistol RDS community.
If I send a Glock slide for an RDS mill job, should I be looking at getting lightening cuts to offset for the increased weight of the RDS? Not necessarily a complete cut either, but just some material to lighten the slide. In fact I'd rather not have a complete fenestration, but if it makes the gun run better with lightening ditches, or whatever you'd call them, I'd totally be open to do it.
So yay, or nay, to lightening ditches, or even complete fenestrations?
Or will a Gen3, 4, or 5 slide run completely fine, with an RDS, with only the mill job and no other chop shop action?
Also! Do any of the common aftermarket RDS slides, from Primary Machine, Agency Arms, et. al., have breech faces optimized to keep brass out of the glass?