I bought two sets of Straight 8s for intalation into my two HKs, I installed the P30 sights but found that both front and rear required more "fitting" than I anticipated. From Henies card with the sights I expected a little bit of sanding from the bottom of the dovetail but eneded up needing to take material off the front angle too just to get it to hammer in without pushing up a burr in the sight. The front sight required me to take material off the bottom of the post both front and back to get over the raised stirp running down the center line of the slide. The good news is the gun shoot even better than before and seem solid with the set screw locktited. I'm now about to install the same sights on the HK45 and am wondering if I missed something the first time around or is this normal for these sights?
Thanks.