Page 5 of 5 FirstFirst ... 345
Results 41 to 43 of 43

Thread: Holosun HE509T for $399.99

  1. #41
    Member
    Join Date
    Oct 2013
    Location
    North AZ
    Quote Originally Posted by DMCutter View Post
    I mounted my 509t on my new MR920 yesterday. I had to grind a fraction of an inch off the heads of the cover plate screws to get them below the Holosun mounting plate (0.08" according to Richie at Shadow Systems, but I didn't measure it, just went trial and error). Unfortunately it sits higher than an RMR or 507 so I'm going to have to replace the stock sights with suppressor height. Otherwise there was no drama involved with the mounting and the dot was dead on at 20 yards out of the box.
    Good info thank you. I'm really looking hard at a Flat Dark Earth MR920 Elite so it is good to know that one can 'jimmy' it in there. If it came down to it I could mount my 509T on my Arisaka offset mount for my Recce rifle and get a 508T or even an RMR for the 920.

    ..I would love to have an Agency Arms AOS set up, at least at this point, but a stripped slide costs as much as the whole MR920! Daaaanng..

  2. #42
    Site Supporter dontshakepandas's Avatar
    Join Date
    Jun 2014
    Location
    Dallas, TX
    Quote Originally Posted by DacoRoman View Post
    Good info thank you. I'm really looking hard at a Flat Dark Earth MR920 Elite so it is good to know that one can 'jimmy' it in there. If it came down to it I could mount my 509T on my Arisaka offset mount for my Recce rifle and get a 508T or even an RMR for the 920.

    ..I would love to have an Agency Arms AOS set up, at least at this point, but a stripped slide costs as much as the whole MR920! Daaaanng..
    If you aren't going to direct mill, I'd probably suggest going with something other than the 509t to start with. You'll have a lot more options with something like the 508t since it uses a more standard footprint.

    The 509t does work well as an offset though, I have two that I use for that role.

  3. #43
    Member
    Join Date
    Oct 2013
    Location
    North AZ
    Quote Originally Posted by dontshakepandas View Post
    If you aren't going to direct mill, I'd probably suggest going with something other than the 509t to start with. You'll have a lot more options with something like the 508t since it uses a more standard footprint.

    The 509t does work well as an offset though, I have two that I use for that role.
    Copy! If I get the MR920 I'll do just what you describe, time to look for a 508t just to have that option.

User Tag List

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •