Anything I post is my opinion alone as a private citizen.
FWIW: Glock 17 Gen4 MOS. Forward Controls Design OPF-G, RMR plate. Trijicon RMR Type 2 RM06.
McMaster-Carr
94414A146 - Black-Oxide Alloy Steel Torx Flat Head Screws, 6-32 Thread Size, 3/8" Long, Packs of 50 ($9.12/pack) *Sight-to-plate screw for FCD OPF-G, RMR plate.
91294A126 - Black-Oxide Alloy Steel Hex Drive Flat Head Screw, 90 Degree Countersink Angle, M3 x 0.50 mm Thread, 6 mm Long, Packs of 100 (4.52/pack) *OPF-G, RMR plate-to-slide screw (same screw used for Glock MOS plates).
75145A68 - Reusable Threadlocker, Vibra-Tite Vc-3, 0.17 oz. Tube
Other useful information concerning FCD’s OPF-G, RMR plate:
Plate to slide torque value: 13in/lb
Sight to plate torque value: 13in/lb
"True heroism is remarkably sober, very undramatic. It is not the urge to surpass all others at whatever cost, but the urge to serve others at whatever cost." -Arthur Ashe
Does anyone know the proper MRO screw size for a CZ Shadow2 with CZC slide cut and adaptor plate?
(WTF? Why would CZC not include shorter screws with the plate?)
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
Unfortunately not standard SRO screws (which came with the optic). I guess I'll cut them short with a dremel...
(Getting the CZC plate for Sig Romeo off was a PIA. It took Kroil, and a torch to loosen the screws, but I guess that's a good thing so it didn't come loose during firing.)
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie