$422 for the 3.25 MOA version at BigTex
https://www.bigtexoutdoors.com/produ...c06-c-3100001/
$422 for the 3.25 MOA version at BigTex
https://www.bigtexoutdoors.com/produ...c06-c-3100001/
Was just going to post that. Ordered a 3.25 MOA from BigTex Outdoors.
It is interesting that Holosun sights can hardly be found in stock and this new optic is being discounted. I think if they went with a RMSc (“the Springfield standard”) footprint, they would be selling bushels of them.
Likes pretty much everything in every caliber.
Of course the sales happen after I bought one.
My RMRcc, along with a G43 slide, arrived at Battle Werx today to get milled. I'm looking forward to trying it out.
$430 for the 6.5 MOA at EuroOptic
https://www.eurooptic.com/Trijicon-R...Plate-Kit.aspx
This is the one I ended up keeping over the 3.5.
Who's had a P365 milled for the RMRcc? Who did you use?
Thanks, from what I can tell those two plus AETi seem to be the only ones doing it.
How so? I have several of their plates, but have only used them for milling once. Work was good, but comms sucked and took longer than quoted, plus they lost the sights that were on my slide. They made it right just didn't have a usable gun for about 6 weeks longer than I was quoted.