Ignore.
I just got my 1.0 PC core slide back from c&h. I had them mill the pocket out to 2.0 spec and I bought a DPP plate. Took 7 weeks door to door. Communication wasn’t great but the work looks fine. As far as milling goes this is about as simple as it gets but I don’t know that a lot of shops are offering it.
My 2.0 slide came back today. I’m very happy with it.
I’m going to put a set of Dawson sights on it. These are Ameriglo I-Dots.
I think a direct milled installation on a M&P 2.0 is preferable to the CORE factory solution — especially if you move the optic rearward and put the rear sight in front of the optic. Obviously this doesn’t work with the SRO.
Likes pretty much everything in every caliber.