I've got a JMCK 2.0 34-length I'm getting used to. The screws are backing out a little each time I wear it. I marked the screws to verify as seen in the pic (wore for a few hours). I could use blue 242 or low-strength purple 222 and it would easily hold the screws in place.
I want to be able to make ongoing retention adjustments without worrying about breaking the loctite seal. Past experience says the screws would likely stay put even after breaking the loctite seal because of the residue on the screw and in the post threads but isn't there an alternative that is applied to the screws that firms them up allowing for ongoing adjustments? Thanks