The 1894 I bought in .44 magnum runs .44 special just fine after I fixed the broken carrier.
The 1894 I bought in .44 magnum runs .44 special just fine after I fixed the broken carrier.
3/15/2016
So I went ahead and radiused my hammer on my Marlin 1894 .357 mag. Not having the recommended tools, I used my Dremil tool. I left the hammer on the rifle while shaping it, covering the opening behind the bolt with a rag to prevent shavings from falling in. Using a sanding drum bit I took a little bit off at a time. Each time I would cycle the action slowly and carefully observe how the little knob on the bottom of the bolt was interacting with the hammer. Once I got it “just right” I polished it with Flitz metal polio’s and a felt wheel. I came out better than I had hoped!
I also chamfered the chamber mouth using this countersink I picked up at Home Depot: https://www.homedepot.com/p/RYOBI-Sp...CS72/205472330
The only reasons I used this one was it was cheap, readily available locally and I could use a 1/4 socket and a ratchet extension. I turned it buy hand until I had the chamfer I wanted then polished with Flitz and a felt wheel. This was a 5 fluted counter sink. I think a 6 flute might work a little better with less chatter but it did the job. It now chambers all the bullet styles I have tried with no hangups.
Last edited by 4given; 06-22-2020 at 08:46 AM.
With the work you have done to it, it sounds like it is going to have a great action and be a very fun little all around gun.
Are you guys doing this on new production Remington-Marlin 1894s, or the older ones that I am told are better-made?
Join FPC
Join FPC
Mine is at least 5 years old, but nothing is hugely wrong with it. The fit and finish isn't great, like the stock doesn't line up nicely with the receiver and things like that, but nothing that affects functionality. It is a more difficult to load, and has rough edges that get to your thumbs after a while, and the action isn't nearly as nice as a Henry, things like that. I have no idea if the pre-Remington Marlins are better, I have never seen one, just read Internet gospel on the topic.
Join FPC
I was into 10mm Auto before it sold out and went mainstream, but these days I'm here for the revolver and epidemiology information.