Working on installing my Holosun 507C-V2 on to my 19.5 MOS. The screws that came in the "Holo" bag turned out to be too short, but the RMR screws seem to be just fine. Waiting on the VC3 to dry as I type this.
Working on installing my Holosun 507C-V2 on to my 19.5 MOS. The screws that came in the "Holo" bag turned out to be too short, but the RMR screws seem to be just fine. Waiting on the VC3 to dry as I type this.
“Conspiracy theories are just spoiler alerts these days.”
I haven't watched this yet, but it popped up on my recommended list last night.
I skimmed the video FWIW. He drops his units repeatedly, and I get it’s his schtick, but sheesh...
I’ve had a C&H “Defender” plate/RMR2 for a couple of weeks on a dept. gun. VERY impressed with the the thinking that seemed to go into it. Only a few hundred rounds on the combo, and I didn’t throw it against the indoor range concrete-so far so good. I’ll continue to run it and report any issues. In my opinion, it’s a reasonable choice for carry and compliments/protects the RMR, especially the forward face of the lens.
I put the defender on my G34.5. 2 matches and couple range trips so far is been great.
Sent from my Pixel 2 using Tapatalk
I’ve purchased two V4 MIL/LEO plates from CHPWS for the Holosun family and I could not be more pleased. To say that they’re a massive improvement over the clunky OEM MOS plate would be an understatement.
Sent from my iPhone using Tapatalk
Any updates from people using the V4 Defender? I really like the idea of the forward lens protection. I’d be replacing a V3 plate that has been good on my 19.5.
Ken
BBI: ...”you better not forget the safe word because shit's about to get weird”...
revchuck38: ...”mo' ammo is mo' betta' unless you're swimming or on fire.”
My sample size is two: first one (mine) went on great. Second one (buddy's) came with one screw that was defective and would not thread. Total freak thing completely out of C&He's control. He chose to just use different screws and did not involve C&H. I believe the failure was with one of the screws that mounts the optic to the plate. The factory MOS ones worked in their place.
I did, however, recently receive an M&P CORE 2.0 plate. The screw holes were out of spec (these are just pass-through, non-threaded holes) and would not accommodate a screw of the right dimension to thread into the slide. I emailed C&H inquiring if they would like to exchange it or if I should just drill them out. They said they would send me a replacement and a label to return the defective plate. I received the replacement plate and it was the same thing with the holes bored out (obvious because of unfinished surface). I would have rather been given the option to fix it myself and not be out the gun for several days but they did handle it.
I have the plate with a front lense shroud on a gen 5 glock 17 with a 407c, awesome product and will be buying more.