Do you have to trim the .357 SIG?
I’m tempted to start reloading 7.62 Tokarev but the idea of trimming has turned me off.
Do you have to trim the .357 SIG?
I’m tempted to start reloading 7.62 Tokarev but the idea of trimming has turned me off.
I never had to but I don't think I ever reloaded a case more than once.
Turrets will be much, much more efficient than single staging it. I've watched enough accuracy reviews of the same load developed on a turret vs. a single stage, out of two different revolvers, to know there's absolutely zero difference in accuracy out of handguns so let's get that production number up some more. Long range shooting with a skilled shooter and good kit, you might find some differences.
The Lee classic or value turrets are cheap to buy and cheap to change calibers without having to setup your dies each time.
I just left them laying on the ground if I had reloaded them. I had enough problems getting the sizing and seating right and all the failures in reloading were due to my inability to get the necks and seating correct. When I was reloading this round I had plenty of brass, I just did not care to go for two reloads...lazy.
I have no idea how many reloads a case for this cartridge is good for.
The only pistol cartridge I have ever loaded that was a bigger PIA than this one is the .44-40...it is worse and I loose more brass on that one.
I congratulate all the reloaders who have mastered .357 Sig and had very little problem getting it up and running...I am not one of them.
Last edited by fatdog; 04-12-2020 at 01:10 PM.
What brand dies? I've found the ones that full length resize and neck expand in the same operation can be troublesome with mixed brass. Along those same lines, the seater / crimp die can also give me trouble with mixed brass as the case length variation can be enough to leave a slight bell on some brands, and over crimp on others.
Participation does not equal Proficiency
- Mike Pannone
I reload 357 on a Dillon 550 with Hornady dies and have never had any issues with sizing. I guess I do run the fired cases through a bulge-buster sort of arrangement every so often, but everything works just fine for me. I crimp with a LEE collet type factory crimp die.
I still reload everything on a single stage press. I’ve done quite a few .357 sig rounds. My preferred method is to size the cases twice, once with a carbide.40 s&w die, then with the 357 sig die. This way I avoid having to lube cases. I’ve never needed to trim 357 sig brass. I also run the rounds thru a Lee factory crimp die after seating using the RCBS seat/crimp die, just to be sure the bullet won’t set back.
The first indication a bad guy should have that I'm dangerous is when his
disembodied soul is looking down at his own corpse wondering what happened.