I installed the mini tail hook brace this morning. So far I really like it. It’s very similar in size to the spinner.
It folds completely, and only rubs a tiny bit.
The only issue I had is the screw thingy design to hold the adapter in place bottoms out long before getting “tight”. It is deep enough that it’s made a slight indent into the stock but it sticks out and spins easily. I just put a drop of loctite on it
I’m not worried about it. The newer sig spinner adapter is plastic/rubber rather than the metal one in the installation video I watched. It does not have the extra clamping screws. I had to gently hammer it on and I cannot pull it off by hand pulling as hard as I can. It would require tools. I wouldn’t even worry about the extra screw honestly.
The only concern I have is that the flexible rubber brace may actually account for some of the soft recoil effect of the rattler. I’m wondering if the stiff metal will make a difference. Obviously overthinking it but time is all we have at this point 🙂
Edit: this probably belongs in the proposed rattler enabler thread. Who’s idea was that anyway? 🙂