Yes I did. My bad though I have yet to shoot it. My take and changes. The factory grip make the reach to the trigger really long. I am used to Ruger GP with the compact grips and this piece is bigger in reach. So I changed grips to a set of Altamonts. The Altamonts are really nice but didn't change the reach much.
The DA pull weight was bad and had some grit to the pull. I took it apart. I polished the hammer spring strut where the spring would rub on it. Not anything hard to do. I do this on Ruger GP and SP series as well. I switched out hammer and trigger return springs from Galloway Precision. Now the DA trigger pull much more acceptable.
I must say the finish on the inside of the revolver and the parts themselves look pretty good. Of course most big parts are MIM but the CNC machining inside looks good.
The revolver fits in any of the leather holsters I have had made for my 3 inch GP 100's.
More to come after I shoot it. I also removed the stupid red tape stripe on the front sight and actually applied sight paint.