Got an order in from Langdon Tactical this afternoon with a set of LTT grips for my Beretta 92F along with some other parts. Put the grips on just fine and when tightening down one of the screws (factory Beretta hex-head screws) the head broke clean off. A stub of the screw remained in the bushing, but was not tall enough to get ahold of to turn out. I drilled out the stub with a 1/16" drill bit in the hopes of being able to then turn the stub out of the bushing, but had no luck. Here's a picture of where things stand now:
Any thoughts on how to remove the stub of the grip screw? Or am I better off just removing and replacing the whole bushing? If that's the best course of action, how should I go about removing the bushing?